Select Page

3D Print Your Own Thermal Insert Press

3D Print Your Own Thermal Insert Press

Written by David

October 1, 2019

[post-views]

Thermal inserts are a big thing when it comes to engineering with plastic. They make it easy to use threaded fasteners with plastic parts, and they work great with 3D printing too.

 .

There’s a bit of a knack to installing them without damaging your workpiece, however, and [John Culbertson] wanted to make using them as easy as possible. Thus, he created a thermal insert press of his very own ! If you’re not using heat-set inserts with your 3D printed parts you’re missing out.

 .

Hackaday’s own [Joshua Vasquez] wrote a great guide on thermal inserts which you heat up to securely melt the plastic as they are pushed into a slightly under-sized hole. While it’s possible to install these inserts by hand, using a press means much more consistent results. This press relies on 3D printed components in combination with off-the-shelf bearings and fasteners. There’s a linear rail as […]

You May Also Like…

Pin It on Pinterest

Share This

Share this post with your friends!

Shares